Redundant Power Supply Packages
using Switching Regulated Power Supplies
AC-DC single output
- Shipped Within 9 Days
- All Models U.L. Recognized
- Five Year Warranty
Rack Mounting & Wall Mounting
Specifications
Input Voltage: 90-132 VAC, 49-61 Hz, single phase. For models R24W7, RWL24W7, R28W7, RWL28W7, R48W7 and RWL48W7, the use of 30A lines is recommended. When operating on 50 Hz input, derate output by 5%.
A separate set of AC input terminals is provided for each power supply, so that if two sources of AC input power are available, one may be used for each supply and so reduce the possibility of output dropout due to loss of input power.
Output Voltage:
Normal mode: Nominal
voltage shown in table.
Backup mode:
0.2 volts less than nominal voltage shown in table.
Output Voltage Adjustment Range: ±0.5 volt minimum.
Load Regulation: ±0.05% (Dynamic regulation - does not include 0.2 volt shift which occurs during switchover to lower-set backup supply.)
Line Regulation: ±0.05%
Ripple: 15 mV rms, 100 mV p-p. (48 volt outputs;25 mV rms, 150 mV p-p.)
Remote Voltage Sensing: Provision for sensing the output voltage across the load, so that drops in the load line are compensated, is a standard feature.
Load Protection: Overvoltage protection.
Overload/Short Circuit Protection: Foldback current limiting with automatic recovery.
Polarity: Output is floating; either positive or negative output terminal may be grounded or floated up to 300 volts above ground.
Voltage Monitor Circuits: One for each power supply. Relay contacts switch when output voltage decreases approximately 2 volts from the nominal rating (approximately 3 volts for outputs over 48 volts), and may be used to control an external failure alarm.
Alarm Relay Contact Ratings: 120 VAC, 8A / 60 Vdc, 1A. (To comply with SELV requirements, limit switched voltage to 60 Vdc / 42 VAC.)
Output Metering: Two voltmeters (standard). Ammeters available; see Options.
Temperature Coefficient: 0.02%/°C (Typical)
Ambient Operating Temperature: 0 to +71°C.
Storage Temperature: -40 to +85°C.
Terminal Strip Cover: Clips on.
Size and Weight:
Case | Mounting | Rough Dimensions | Approx. Size | Type | (inches) | weight ------|----------------|---------------------------|--------- 5RW16 Rack Mounting 5.3 x 19" panel, 16.8" Deep 21 lb. --------------------------------------------------------------- 5RW18 Rack Mounting 5.3 x 19" panel, 18.8" Deep 27 lb. --------------------------------------------------------------- 5RW22 Rack Mounting 5.3 x 19" panel, 22.8" Deep 32 lb. --------------------------------------------------------------- 519RW15 Wall Mounting 15.5 H x 19 W x 6.1" Deep 24 lb. --------------------------------------------------------------- 519RW18 Wall Mounting 18.5 H x 19 W x 6.1" Deep 27 lb. --------------------------------------------------------------- 522RW17 Wall Mounting 17.3 H x 22.5 W x 6.1" Deep 33 lb. --------------------------------------------------------------- See Drawing for exact dimensions